[altq 891] Re: Configuration of Altq

[Nacho Gutierrez <nacho@centrocom.es>]

Also, you can use "exactbandwidth" instead of "pbandwidth":

class cbq rl0 netone internet exactbandwidth 150K borrow

Nacho.

El día Thu, 21 Jun 2001 11:28:26 -0700, "Tom Wang" <tom.wang@mail.com> dijo:

> If you want to config small bandwidth, you should use dummynet, it can setup
> tens-kilo bps to a flow pipe, and tens-mega bps to another.
> ----- Original Message -----
> From: Manuel Forget <forget@iie-evry.fr.to>
> To: <altq@csl.sony.co.jp>
> Sent: Tuesday, June 19, 2001 8:36 AM
> Subject: [altq 877] Configuration of Altq
> 
> 
> > I use altq on a bridge to divide a 100Mbits connection, but 1% (1Mb) is
> not
> > enough small for what I want to do. Can I use floats for the percent ?
> > If not, can I use a smaller bandwidth in the interface and apply a filter
> to
> > the def_class. Some connection will so pass trough the rules of Altq (the
> > smalles bandwidth) and the other through the entire 100Mbits.
> >
> > Thanks, Manuel Forget
> >
> >
> >

---------------------------------------------------------------------------
Nacho Gutiérrez Losada, nacho@centrocom.es
Centrocom, Agencia de Comunicación Interactiva
http://www.centrocom.es
---------------------------------------------------------------------------
    ()    ascii ribbon campaign - against html mail
    /\                          - against ms attachments
---------------------------------------------------------------------------