[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[altq 232] Using ALTQ on high bandwidth links

To: "ALTQ ML" <altq@csl.sony.co.jp>
Subject: [altq 232] Using ALTQ on high bandwidth links
From: "Fulvio Risso" <risso@polito.it>
Date: Fri, 26 Nov 1999 08:48:03 +0100
Importance: Normal
Reply-To: altq@csl.sony.co.jp
Sender: owner-altq@csl.sony.co.jp

Hello everyone.
I'm just thinking about the use of ALTQ on high bandwidth and wide area links. Goal is to create a WAN with (perhaps) 34Mbps point to point links and use ALTQ on FreeBSD intermediate routers.
Since I tend to avoid using ATM (because the equipment is too expensive; I do not want to install several ATM switches), do you have any ideas how to make it all?
Which WAN technology can I use / is supported by ALTQ?

Just in case I will be able to use FastEthernet links, which board do you suggest in order to decrease the overhead on my machines?

Thanks to all,

	fulvio

Prev by Date: [altq 231] Re: Diffserv codepoint confusion
Next by Date: [altq 233] Diffserv and the RIO dropper
Prev by thread: [altq 231] Re: Diffserv codepoint confusion
Next by thread: [altq 233] Diffserv and the RIO dropper
Index(es):
- Date
- Thread