[altq 523] ALTQ and OpenBSD 2.7

[David TOUITOU <dtouitou@businessobjects.com>]

Hello all,

I've been trying to setup ALTQ on a OpenBSD computer for last week and I'm
experiencing several problems.

Here's what I've done yet : 

 . setup an OpenBSD 2.7 box (P100 with 64Mb of RAM)
 . put two fxp (Intel EtherExpress) inside
 . setup a bridge (bridge0) using these cards (fxp0 and fxp1)

	This works well

 . add another fxp card and give it an IP address to ssh to the box

	Works well too, even on DHCP

 . download the kame-20000704-openbsd27-stable.tgz tarball
 . untar it, read the README and INSTALL files

	Still goes quite well

 . try to build a kernel

	First issues here...
	I've had "lots" of difficulties to build a kernel based on 
	the GENERIC and ALTQ.v4 files given with the KAME tarball. 
	I've finally had to base myself on the GANDALF file to be 
	able to compile the kernel without errors. 

 . once the kernel is compiled, make the altq devices

	Works well
	I can boot, the bridge is still bridging, no error what so ever.

 . trying to launch altqd

	I've setup a very single /etc/altq.conf file. 
	First line is : interface fxp0 bandwidth 100M cbq

	Every try to launch altqd gives me a :
		CBQ open
		: Operation not supported by device
		syscall error: can't add cbq on interface 'fxp0'
		: Operation not supported by device
		Error in /etc/altq.conf, line 1
		Config Failed. Exiting.

	I've tried to change fxp0 to lo0 (loopback), same issue...

Where I am wrong ?
Which step did I missed ?

Thanks in advance.

-- 
......................................................................
 David TOUITOU                                       Business Objects
 IT Corp UNIXWAN Team                                  Levallois - FR