[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[altq 888] Re: Configuration of Altq
If you want to config small bandwidth, you should use dummynet, it can setup
tens-kilo bps to a flow pipe, and tens-mega bps to another.
----- Original Message -----
From: Manuel Forget <email@example.com>
Sent: Tuesday, June 19, 2001 8:36 AM
Subject: [altq 877] Configuration of Altq
> I use altq on a bridge to divide a 100Mbits connection, but 1% (1Mb) is
> enough small for what I want to do. Can I use floats for the percent ?
> If not, can I use a smaller bandwidth in the interface and apply a filter
> the def_class. Some connection will so pass trough the rules of Altq (the
> smalles bandwidth) and the other through the entire 100Mbits.
> Thanks, Manuel Forget